15
Operating from a Keypad
This section describes how to operate your system from a keypad.
The operations at keypads (refer to Table 9) will only affect the partitions
controlled by the code and keypad concerned.
WARNING - The Factory Default User Codes (0001-0024) must be chan-
ged for security reasons (refer to ‘Programming Codes’ in this section).
Global Arming (Code + ON)
This command will Arm all the partitions controlled by the code and keypad.
If you are working from a LED keypad, ensure that the Green LED V is ON.
Basic Operations
Changing User
Codes
()
"#$%&
'
&&( #
=),>
=),>
=,>
<
=,>
<50,
+
=),>
=),>
=,>
=,>
<
=),>
=),>
=,>
5*+
=),>
=),>
=,>
5*+
=),>
=,>
50&&3&0%&
&-/422&<+
=),> 50+
=),>
!"5"-+
*%!
5",+
?
9!
=>
9!
Ö
To Next Page
Loading...
Need help?
General
