19
Operating from a Keypad
Reset Alarm or Clear Alarm Memory
The ‘Reset Alarm’ and ‘Clear Alarm Mem.’ options depend on the system status.
If the system is in Alarm status the Menu will provide the ‘Reset Alarm’ op-
tion. This option will allow you to stop the audible and visual signalling devices
(Sirens, Flashers, etc.).
If the system is in Normal status the Menu will provide the ‘Clear Alarm
Mem.’ option. This option will allow you to clear the Alarm messages from the
Keypad display, or turn OFF the keypad lights.
Table 10 shows when and how you will be able perform Reset on Control panels.
To Reset an Alarm, or Clear the Alarm Memory from an LCD keypad, proceed
as follows:
1. From the User Menu, using C or D, scroll the
Menu for the Reset Alarm or Clear Alarm
Mem. option, as required.
2. Press
ENTER to Reset Alarm / Clear Alarm
Mem., as required. Acceptance of the command
will be confirmed by a beep and a short message.
To Reset an Alarm or Clear the Alarm Memory from an LED keypad, proceed
as follows:
1. Access the User Menu.
Code PIN + ENTER
The P indicator will blink.
2. Press 0 to Reset Alarm / Clear Alarm Mem., as required, or ESC to
cancel the request and, in both cases, exit the Menu.
NOTE: If your installer has enabled the ‘Auto-Reset Memory’ option, your
system will reset automatically at each Arming operation.
If you are using an LED Keypad, you will be able to retrieve any Alarms in the
Alarm Memory which occurred previous to the last Reset operation. To Check the
Alarm Memory, proceed as follows:
Code PIN + ENTER + 8
If you are using a KYO32 Control panel, this option is available with Alison/
32LP Keypads only.
USER MENU ßà
Clear Alarm Mem.
Clear Alarm Mem.
Operation done
LCD Keypads
USER MENU ßà
Reset Alarm
LED Keypads
Retrieve Alarms
in Memory
To Next Page
Loading...
Need help?
General
