Bentel Security KYO 4M User Manual

17

Operating from a Keypad
Notes on Arming from Keypads
Before your system Arms, your Control panel will check for the following condi-
tions:
 Violated zones (zones in Alarm status)
 Bypassed zones (zones which have been turned OFF)
If you are operating from an LED keypad, these conditions will be signalled in real-
time on the X and V icons (refer to Table 3).
If you are operating from an LCD keypad, these conditions will be signalled in
real-time on the display.
If Alarm conditions are signalled, DO NOT turn ON your system, as this will
trigger an Alarm.
The example (on the right) shows zone 2 as Bypas-
sed (OFF) and zone 4 in Alarm status (Violated).
If Alarms are signalled — press
ESC to cancel the
Arming request.
Close all doors and windows, and stop all motion in the areas (partitions)
with motion detectors.
If zones have been Bypassed unintentionally — press
ESC to cancel the Arming
request.
 Access the User Menu, select the ‘Zone status’ option and Unbypass (turn
ON) the unintentionally Bypassed zones.
If your installer has enabled your system, you can view any Violated zones (zones
in Alarm status) on the display even when the system is Disarmed.
Silencing Alarm Devices from Keypads
The quickest way to silence Alarm Signalling Devices (Sirens and Flashers) is to
Disarm the system.
IMPORTANT - This operation will not interrupt the ongoing Alarm call, or end the
Alarm call cycle. Therefore, it will be necessary access the User Menu (access allowed
to Main User PINs only), and stop the Alarm calls, via the ‘Clear Call Queue’ option.
Tamper events, which occur when the system is disarmed, can be silenced via the
‘Reset Alarm’ option from the User Menu (access allowed to Main and User PINs).
For further information, refer to ‘Silence Alarm Signalling Devices from Reader’
paragraph in the ‘Using Digital Keys/Cards’ section.
Wrong Code
If a wrong code is entered, the keypad will emit an error signal (buzz), and the
display will show an error message. If your Installer has enabled the ‘lockout’
feature, the keypad will lock for 2 minutes after 5
wrong entries.
WRONG CODE
LED Keypads
LCD Keypads
Zone 2
BypassedNormal å
Zone 4
Unbypas.Alarm å
Clear Call Queue
Silence Tamper
Alarms

Bentel Security KYO 4M Specifications

General

Brand	Bentel Security
Model	KYO 4M
Category	Control Unit
Language	English