Bentel Security KYO 4M User Manual

24
Multifunction Control Panel

Enable/Disable Teleservice
If this option is OFF the system will not accept incoming Teleservice calls, and on-
line Installer intervention will not be possible.
To enable/disable Teleservice from an LCD keypad, proceed as follows:
1. From the Main User Menu, using key
C or D,
scroll the menu for the En./Dis. Teleser. option,
then press
ENTER.
2. Press
ON to enable or OFF to disable Teleservice.
3. Press
ENTER to confirm and go back to step 1.
When the Teleservice is ON, an asterisk ‘*’ will be
shown over the t icon , as illustrated in the example
(to the right).
To enable/disable Teleservice from an LED keypad, proceed as follows:
1. Access the Main User Menu.
Code PIN + ENTER
The P indicator will blink.
2. Press 2 to toggle the status — Enable Ö Disable (refer to Table 12).
3. Press ENTER to confirm, or ESC to quit and, in both cases, exit the Menu.
The P indicator on LED keypads will turn ON to signal “Teleservice enabled”.
USER MENU ßà
En/Dis. Teleser.
En/Dis. Teleser.
ON <OFF>
LCD keypads
LED Keypads
08/11/2002 14:55
DDDDDDDD *

*/'01
 
5HG
.

%-4"-5

+
%.*4"-
+
%-4"-5

+
%.*4"-


Bentel Security KYO 4M Specifications

General

Brand	Bentel Security
Model	KYO 4M
Category	Control Unit
Language	English