42
Multifunction Control Panel
Arm — A Mode
This operation will Arm or Disarm the Partitions in accordance with the A Mode
Arming configuration (programmed by the Installer).
To Arm the System in A Mode (Amber LED ON), proceed as follows:
From ECLIPSE Readers
1. Insert the SAT Key into the ECLIPSE Reader. The Red LED will turn ON
(see Figure 8b).
2. Push the Key once against the Reader switch (located to the back of the
Reader slot). The Amber LED will turn ON (see Figure 8c).
3. Remove the Key. At this point, the Red LED will also turn ON and the System
will Arm in A Mode.
From PROXI Readers
1. Hold the Proximity Key/Card near the sensitive field of the PROXI Reader.
The LEDs will light in turn (at 2 second intervals).
2. Remove the Key/Card when the Amber LED turns ON. At this point, the Red
LED will also turn ON and the System will Arm in A Mode.
Arm — B Mode
This operation will Arm or Disarm the Partitions in accordance with the B
Mode Arming configuration (programmed by the Installer).
To Arm the System in B Mode (Green LED ON), proceed as follows:
From ECLIPSE Readers
1. Insert the SAT Key into the ECLIPSE Reader. The Red LED will turn ON
(see Figure 8b).
2. Push the Key twice against the Reader switch (located to the back Reader
slot). The Green LED will turn ON (see Figure 8d).
3. Remove the Key. The Red LED will also turn ON and the System will Arm
in B Mode.
From PROXI Readers
1. Hold the Proxomity Key/Card near the sensitive field of the PROXI Rea-
der. The LEDs will light in turn (at 2 second intervals).
2. Remove the Key/Card when the Green LED turns ON. At this point, the
Red LED will also turn ON and the System will Arm in B Mode.
To Next Page
Loading...
Need help?
General
