43
Operating the System from a Telephone
Silencing Alarm Signalling Devices from ECLIPSE
Readers
In the event of a False Alarm, the quickest way to silence the Alarm Signalling
Devices (Sirens and Flashers) is to insert a Sat Key into ECIPSE Reader and
Disarm the system. If your Installer has programmed the SAT Key to ‘Clear
the Call Queue’, this operation will also end the ongoing Alarm call, and stop
the Alarm call cycle. If not, it will be necessary to stop the Alarm calls manual-
ly (refer to ‘Clear Call Queue’ in the ‘Keypads’ section).
For further information, refer to ‘Silence Alarm Signalling Devices from
Keypads’ in the ‘Operating from Keypads’ section.
Inhibit Alarms (Service Mode)
This operation will block the Alarm Outputs, and prevent the System from si-
gnalling Alarms.
To Stop Alarms — insert a SAT Key into an ECLIPSE Reader (see Figure 8e).
If your Installer has programmed the SAT Key to ‘Clear the Call Queue’, this
operation will also end the ongoing call, and stop the Alarm call cycle. If not, it
will be necessary to stop the Alarm calls manually (refer to ‘Clear Call Queue’
in the ‘Keypads’ section).
On LED Keypads, this status will be signalled by the
V indicator. On LCD Keypads, this status will be
signalled by a message (see example to the right).
As soon as the SAT Key is inserted into the Reader,
the Red LED will switch status, and the Amber and
Green LEDs will turn OFF.
G To restore the previous setting (go back to the Arming mode which was
active when you inserted the SAT Key) — push the SAT Key into the ECLI-
PSE Reader until the 3 LEDs start to blink slowly, the previous setting will
be restored when the Key is removed.
Test
DDDDDDDD
Test Vibrat 012
DDDDDDDD
To Next Page
