50
Multifunction Control Panel
A Mode Arming
This operation will Arm or Disarm the Partitions in accordance with the A Mode
Arming configuration (programmed by your Installer).
Press the button for approximately 2 seconds, to Arm the system in A Mode
— in accordance with the Code (0023 or 0024) of the Wireless Key in use.
This operation will have the same effect as entering <Code> +
A at a Keypad.
B Mode Arming or Superkey 2
This operation will Arm or Disarm the Partitions in accordance with the B Mode
Arming configuration (programmed by your Installer).
Press the
button for approximately 2 seconds, to Arm the system in B Mode
— in accordance with the Code (0023 or 0024) of the Wireless Key in use.
This operation will have the same effect as entering <Code> + B at a Keypad.
If your Installer has set up number key 2 as a Superkey 2 (refer to the ‘Supe-
rkeys’ in the ‘Operating from a Keypad’ section), you will not be able to Arm your
system in B Mode by means of Wireless Keys.
GG
GG
G The operations performed by Wireless Key will not be confirmed by any
type of feed back signal (audible or visual), unless done in the vicinity of a
Reader, Keypad or feed back signal device set up by the installer.
To Next Page
