46
Multifunction Control Panel
Entering Commands
Once your Telephone Access Code has been recognized, you can enter the
Command Codes. If you enter a wrong Command Code the system will emit an
audible feedback signal (buzz).
NOTE - The system will end the call automatically, if no Key is pressed
within 1 minute.
Cancel Command
Press
to cancel the Command, and step back to the Enter data phase.
Press
to cancel entered digits: the system will emit an audible feedback
signal (2 beeps) to confirm that the data has been cancelled.
Stop Alarm / On Hook
If you are accessing your system via ‘Answer’ mode, press
to end the call.
If you are accessing your system via ‘Dialler’ mode (after receiving an
Alarm message), press
to stop the ongoing Alarm, and Alarm calls.
Remote Talk / Listen-in
Press
to start the Remote Listen-in session. Press
again to start the
Remote Talk session. Press
again to switch from Talk to Listen mode
as required. This feature will allow you to listen to what is happening on the
protected premises (via the microphone on the NC2VOX board), and talk to
whoever is present.
Remote 2Way Talk / Listen-in
Press
to start the Remote Listen-in session, then press
to start the
Remote 2way Talk / Listen-in session. This feature will allow you to listen
to what is happening on the protected premises (via the microphone on the
NC2VOX board), and talk to whoever is present, without switching from
Talk to Listen mode. This feature is useful in Emergency situations, espe-
cially where elderly people are concerned, as it can be activated by Panic
Pendants.
Turning Appliances ON/OFF (Reserved Outputs)
If your installer has set up your system to manage electrical appliances, this
features will allow you to turn them ON and OFF over the phone.
Press
to access Appliances Management session.
Use keys
through
to turn the corresponding Appliance (Output) ON or OFF.
The status will be indicated by a feedback signal:
1 beep Ö Output OFF
3 beeps Ö Output ON
To Next Page
Loading...
Need help?
General
