39
Using Digital Keys and Cards
b) Fast Blinking on all 3 LEDs - This will occur when a false key/card is
present at the Reader.
c) Slow Blinking on all 3 LEDS (ECLIPSE Readers only) - This mode will
allow you to restore the previous setting (reset the Arming mode which was
active before the SAT Key was inserted. For Reset — push the SAT key into
the ECLIPSE Reader until the 3 LEDs start to blink slowly, the previous set-
ting will be restored when you remove the Key.
d) Red LED ON - The system will arm when you remove the key/card from
the Reader.
e) Amber LED ON - The system will arm in A Mode when you remove the
key/card from the Reader.
f) Green LED ON - The system will arm in B Mode when you remove the
key/card from the Reader.
NOTE: Your installer may have disabled the Reader LEDs, therefore,
they will not turn ON even when a valid key/card is used.
To Next Page
