15
®®
Operating from a Keypad
The Keypad Buzzer will emit an audible signal each time a valid key is pressed,
and will also signal:
% The Exit Time (signalled by slow beeps)
% The Entry Time (signalled by fast beeps)
% Errors or Invalid requests (signalled by a Buzz)
% Request Accepted or Done (long beep)
% Violation of a ‘Chime’ zone
Buzzer
Superkeys
If your Installer has set up the 3 Superkeys (refer to Table 1). You will be able to
operate your system from the keypad, without using Codes. The ‘Superkeys’
can activate the:
% Digital Communicator — transmits event codes to the Central Station
% Dialler — sends a voice message (requires NC2/VOX Voice board)
Up to 8 Telephone numbers can be programmed for these commands.
A long beep will confirm that the selected facility has been activated.
ÌÐè
ÌÐè
To Next Page
Loading...
