Bentel Security KYO - Remote System Operation via Telephone; Telephone Access Methods

42
Multifunction Control Panel
®®
OPERATING THE SYSTEM FROM A TELEPHONE
If your system is equipped with a NC2/VOX Voice board (accessory item), and
your Installer has programmed Telephone Access Codes, you will be able to
control your system via any touch-phone.
The Telephone Access Codes are not the same as 4-6 digit System Access
Codes (Main User Code, User Code, etc.). These codes control the system via
telephone only. Each Telephone Access Code can be programmed to control
specific functions and Partitions.
You can access the system over the phone:
a ) after receiving a call from the Control panel;
b) after calling the Control panel and activating the Answering function.
Remote Telephone Access via ‘Dialler’ mode
Remote Telephone Access via ‘Answer’ mode
If your Installer has set up your system to manage the Dialler facility, your
system will be able to call programmed telephone numbers and send voice mes-
sages to alert contact persons of Alarm events (this control panel manages up to
8 Telephone Numbers).
If you receive a Dialler call, you will be able to access your system during the call,
by entering your Access Code on the telephone pad.
You can enter your Telephone Access Code while the message is playing, or
during the pauses between message announcements.
The following paragraphs provide step-by-step instructions for each function.
If you are using a Control panel from the KYO4-8 Series, the ‘Answering
facility’ can be Enabled/Disabled by the Installer ONLY.
If you are using a Control panel from the KYO32 Series, the ‘Answering facili-
ty’ can be Enabled by means of a Main User Coded (refer to Enable/Disable
Answer Function).
G The Answering function must be Enabled, otherwise, you will not be able to
access your system via remote telephone. For the security of your codes, DO
NOT use a telephone with a redial button to Arm or Disarm your system.
If you are accessing your system via the ‘Answering device’ function, two
situations are possible:
% Teleservice Enabled
% Teleservice Disabled
All manuals and user guides at all-guides.com