38
Multifunction Control Panel
®®
b) Fast Blinking on all 3 LEDs - This will occur when a False Key/Card is
present at the Reader.
c) Slow Blinking on all 3 LEDS (ECLIPSE Readers only) - This Mode will
allow you to restore the previous setting (reset the Mode Arming that was
active before the SAT Key was inserted. For Reset — push the SAT Key
into the ECLIPSE Reader until the 3 LEDs start to blink slowly, the previous
setting will be restored when you remove the Key.
d) Red LED ON - The System will Arm when you remove the Key/Card from
the Reader.
e) Amber LED ON - The System will Arm in A Mode when you remove the
Key/Card from the Reader.
f) Green LED ON - The System will Arm in B Mode when you remove the
Key/Card from the Reader.
NOTE: Your Installer may have disabled the Reader LEDs, therefore, they
will not turn ON even when a valid Key/Card is used.
Digital Key/Card operations
Multiple Systems
The Digital Keys/Cards can be programmed (by the Installer) to operate on more
than one System, and to manage different Partitions on each System.
The Digital Keys/Cards can:
% Arm — Global Mode
% Disarm
% Arm — A Mode
% Arm — B Mode
% Stop Alarms
Disarm (Turning OFF your system)
This operation will Disarm all the Partitions controlled by the Digital Key/Card
and Reader in use.
To Disarm the System (all LEDs OFF), proceed as follows:
1. Put the SAT Key into the ECLIPSE Reader, or hold the proximity Key/Card
near the sensitive field of the PROXI Reader — until all the LEDs turn OFF
(see Figure 8a).
2. Remove the Key/Card to Disarm the System.
The PROXI Buzzer
The PROXI Buzzer (if enabled) will signal:
% The Exit Time (double beep at 2 second intervals);
% The Entry Time (continuous fast beeps)
% Violation of ‘Chime’ Zones (a few fast beeps)
To Next Page
Loading...
