Bentel Security KYO - Telephone Arm;Disarm and Code Management

45
®®
Operating the System from a Telephone
Press
%%
%%
% to access Appliances Management session.
Use keys
##
##
# through
&&
&&
& to turn the corresponding Appliance (Output) ON or OFF.
The status will be indicated by a feedback signal:
% 1 beep " Output OFF
% 3 beeps " Output ON
Press
!!
!!
! to confirm the selected status and step back.
Press
!!
!!
! to exit.
Arm / Disarm
Press
''
''
' to access Arm/Disarm management.
This following keys will allow you to Arm / Disarm the system as required.
%
((
((
( " The system will Disarm
%
##
##
# " The system will Arm in Global mode
%
$$
$$
$ " The system will A Mode
%
%%
%%
% " The system will B Mode
After pressing the required key (as above), the system will wait for you to end
the communication. Press
!!
!!
! to end the call.
Enable / Disable Telephone Access Code
This command will allow you to Disable the Telephone Access Code after
using it to access the system.
This is a toggle command, therefore, you can Disable then Re-Enable the Tele-
phone Access Code during the same call:
% Press
))
))
) to Disable the Telephone Access Code, the code will be Disabled
when the call ends.
% Press
))
))
) again to Enable the Telephone Access Code, the code can still be
used for future actions via telephone.
The status will be indicated by a feedback signal:
% 1 beep " Access Code Enabled
% 3 beeps "Access Code Disabled
Press
!!
!!
! to confirm the selected status.
G This security feature will allow you to protect your system against unauthorized
access via Telephone. If you disable a Telephone Access Code via telephone, it
cannot be used again until you Re-Enable it via the User Menu.
To Re-Enable a Telephone Access Code (Disabled via telephone), use the
‘Program Codes’ option from the User Menu (access allowed to Main User
Codes only).
All manuals and user guides at all-guides.com