EasyManua.ls Logo

Bentel Security KYO - Remote Command Entry

Bentel Security KYO
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
44
Multifunction Control Panel
®®
Entering Commands
Once your Telephone Access Code has been recognized, you can enter the
Command Codes. If you enter a wrong Command Code the system will emit an
audible feedback signal (buzz).
NOTE - The system will end the call automatically, if no Key is pressed within 1
minute on KYO 32, and 2 minutes on KYO 4-8.
Cancel Command
' Press
!!
!!
! to cancel the Command, and step back to the Enter data phase.
' Press
!!
!!
! to cancel entered digits: the system will emit an audible feedback
signal (2 beeps) to confirm that the data has been cancelled.
Stop Alarm / On Hook
' If you are accessing your system via ‘Answer’ mode, press
""
""
" to end the call.
' If you are accessing your system via ‘Dialler’ mode (after receiving an Alarm
message), press
""
""
" to stop the ongoing Alarm, and Alarm calls.
Remote Talk / Listen-in
% For KYO4-KYO8 Series
' Press
##
##
# to start the Remote Listen-in session.
% For KYO32 Series
' Press
##
##
# to start the Remote Listen-in session. Press
##
##
# again to start
the Remote Talk session. Press
##
##
# again to switch from Talk to Listen
mode as required. This feature will allow you to listen to what is happe-
ning on the protected premises (via the microphone on the NC2VOX
board), and talk to whoever is present.
Remote 2Way Talk / Listen-in
% For KYO4-KYO8 Series
' Once in the Listen-in session, press
##
##
# again to start the Remote Talk/
Listen-in session.
% For KYO32 Series
' Press
$$
$$
$ to start the Remote 2way Talk / Listen-in session. This feature
will allow you to listen to what is happening on the protected premises
(via the microphone on the NC2VOX board), and talk to whoever is
present, without switching from Talk to Listen mode. This feature is
useful in Emergency situations, especially where elderly people are con-
cerned, as it can be activated by Panic Pendants.
Turning Appliances ON/OFF (Reserved Outputs)
If your installer has set up your system to manage electrical appliances, this
features will allow you to turn them ON and OFF over the phone.
All manuals and user guides at all-guides.com

Table of Contents

Related product manuals