43
®®
Operating the System from a Telephone
Teleservice Enabled
If the ‘Answer’ and ‘Teleservice’ functions are both enabled (refer to ‘Enable/
Disable Teleservice’ in the ‘OPERATING FROM KEYPADS’ section) your
system will answer your call after the programmed number of rings. It will
emit a high-pitch audible signal (beep), wait 35 seconds, then emit 5
beeps to indicate that it is ready to accept your Telephone Access Code.
Teleservice Disabled
If the ‘Teleservice’ function is disabled, your system will answer your call
after the programmed number of rings. It will emit 5 beeps to indicate that
it is ready to accept your Telephone Access Code.
Via Dialler
FunctionMode
Via Answer
Function Mode
Entering Your Telephone Access Code (DTMF)
If you are accessing your system via Dialler Function Mode, you can enter
your Telephone Access Code while the Answering message is playing, or during
the pauses between message announcements.
If you are accessing your Answer Function Mode, you must enter your Tele-
phone Access Code after the 5 beeps.
In both cases:
You must press
!!
!!
!, after entering your Telephone Access Code.
If your system recognizes your code, it will emit an audible feedback signal
(short high-pitched beep), and will accept commands.
If your system DOES NOT recognize your code, it will emit an error signal
(buzz).
The system will end the call automatically, if no valid code is entered within 30
seconds.
To cancel wrong digits, and restart press
!!
!!
!.
To Next Page
Loading...
