BEWATOR COTAG 4101-2 User Manual

4101-2 Controller Installation Handbook
vi
Chapter 16 Connecting Bewator Cotag Readers to 4101-2 Controllers
5291 Proximity Reader...........................................................................16-1
Connections.................................................................................16-1
Controller/module configuration .................................................. 16-1
5291 Reader configuration ...........................................................16-1
5298 PIN & Proximity Reader ................................................................. 16-2
Connections.................................................................................16-2
Controller/module configuration .................................................. 16-2
5298 Reader configuration ...........................................................16-2
BC16 Mag Stripe Reader ........................................................................16-3
Connections.................................................................................16-3
Controller/module configuration .................................................. 16-3
BC16 Reader configuration .......................................................... 16-3
Chapter 17 Earthing and screening
Earthing ................................................................................................17-1
Connecting the cable screens (shields)....................................................17-2
Fitting the ferrite sleeves ........................................................................ 17-3
Chapter 18 Commissioning
Making a plan of the hardware............................................................... 18-1
Setting the Controller and Comms module addresses..............................18-1
Testing the communications to each Controller in a Local
Hardware System...................................................................................18-1
With the host computer connected and on line.............................. 18-1
Without the computer connected ..................................................18-3
Results of checking comms ..........................................................18-3
Testing the communications between the Comms module and the
modem at a remote site.......................................................................... 18-4
Testing the communications to each Controller at a remote site............... 18-5
Teaching 4101-2 Controllers the Distributor Code ..................................18-5
Testing the readers ................................................................................ 18-5
Results of testing the readers .......................................................18-6
Chapter 19 Fault finding
System never worked ............................................................................. 19-1
Getting the comms working ............................................................. 19-2
RS485 connections betweem Comms module and Controllers .......19-2
RS232 connections between PC and Comms module or Controller.19-4
Entering a site code......................................................................... 19-4
Downloading the data from the Software..........................................19-4
Checking the reader modules ..........................................................19-4
Reader not being polled................................................................19-4
Checking the antennas using the 922 Test Card ..............................19-5
No transmit signal .......................................................................19-5
Reduced transmit signal...............................................................19-5
Checking the receive range at the antenna .......................................19-5
Low receive range on a reading head ............................................19-5
Low receive range on a loop antenna ............................................19-5
Correct Tx and Rx range but card not unlocking door ...................19-5
Checking the Software (because no cards are working) ..................... 19-6

BEWATOR COTAG 4101-2 Specifications

General

Brand	BEWATOR COTAG
Model	4101-2
Category	Controller
Language	English