Safety
This equipment must be powered by a supply which is suitably insulated
from the mains. The supply should be classed as SELV under the terms
of EN60950. You are recommended to use a 4910 or 4911 Power Supply
Unit.
The power supply must be connected to safety earth. A mains isolation
switch should be provided by the installer. Any third party equipment
connected must also be suitably insulated from the mains supply.
We also recommend that the 4101-2 Controller is connected to safety
earth via the power supply.
Controller relay outputs must not be connected to mains voltages.
Any fuses which are replaced must be of the recommended rating and
type.
Wiring connected by the installer must be adequate. The use of
inadequate wiring may present a fire hazard.
Except where specified the equipment is not suitable for outside use.
Some of the circuit boards provided contain lithium cells. These must
not be short circuited, dismantled or disposed of in fire. Consult local
regulations on disposal.
Lead acid batteries can present a variety of hazards. Use of batteries
other than those recommended should only be attempted by skilled
personnel. Lead acid batteries must not be short circuited, dismantled
or disposed of in fire. Consult local regulations on disposal.
Except where specified this equipment is not for use in safety critical
applications.
EMC Directive
4101-2 Controllers and 4910/4911 Power Supply Units are independently
tested to the harmonized standards (for emission and immunity) of the
European Community, permitting affixing of the CE mark. The CE mark
symbolizes the fact that the person responsible for the marking has
verified that the product conforms to all the provisions that apply to it.
The signature of the responsible person appears on our declaration of
conformity.
• The incorporation of non-tested components or equipment may
render the purchaser responsible for obtaining their own EMC
Certification for the resulting system.
To Next Page
Loading...
Need help?
General