Field Description
original data packets, as the case arises.
Original Destination IP
Address/Netmask
Only for Type of traffic = %# 5 )3*!
Enter the destination IP address and corresponding netmask of
the original data packets, as the case arises.
Original Destination
Port/Range
Only for Type of traffic = %# 5 )3*!,
Service = $ and Protocol = *6, .5, *6/.5
Enter the destination port or the destination port range of the
original data packets. The default setting 311 means that the
port is not specified.
Original Source IP Ad-
dress/Netmask
Only for Type of traffic = ## % )3*!
Enter the source IP address and corresponding netmask of the
original data packets, as the case arises.
Original Source Port/
Range
Only for Type of traffic = ## % )3*!, NAT
method = (%, Service = $ and Pro-
tocol = *6, .5, *6/.5
Enter the source port of the original data packets. The default
setting 311 means that the port remains unspecified.
If you select +%$( + you can specify a single port, if
you select +%$( + # you can specify a continu-
ous range of ports which will be a applied for filtering the outgo-
ing data traffic
Source Port/Range Only for Type of traffic = >%1# 2 )3*!, Ser-
vice = $ and Protocol = *6, .5, *6/.5
Enter the source port or the source port range of the original
data packets. The default setting 311 means that the port re-
mains unspecified.
Destination IP Ad-
dress/Netmask
Only for Type of traffic = >%1# 2 )3*! or
## % )3*! and NAT method = (%
Enter the destination IP address and corresponding netmask of
the original data packets, as the case arises.
bintec elmeg GmbH
12 Networking
bintec RS Series 223
To Next Page
Loading...
