Field Description
Destination Port/Range Only for Type of traffic = ## % )3*!, NAT
method = (%, Service = $ and Pro-
tocol = *6, .5, *6/.5 or Type of traffic = >%1#
2 )3*!, Service = $ and Protocol =
*6, .5, *6/.5
Enter the destination port or the destination port range of the
original data packets. The default setting 311 means that the
port remains unspecified.
In the NAT Configuration->Replacement Values menu you can define, depending on
whether you're dealing with inbound or outbound data traffic, new addresses and ports, to
which specific addresses and ports from the NAT Configuration->Specify original traffic
menu can be translated.
Fields in the menu Replacement Values
Field Description
New Destination IP Ad-
dress/Netmask
Only for Type of traffic = %# 5 )3*!
Enter the destination IP address and corresponding netmask to
which the original destination IP address is to be translated.
New Destination Port Only for Type of traffic = %# 5 )3*!,
Service = $ and Protocol = *6, .5, *6/.5
Leave the destination port as it appears or enter the destination
port to which the original destination port is to be translated.
Select -#1 to leave the original destination port. If you
disable -#1, an input field appears and you can enter a
new destination port.
-#1is active by default.
New Source IP Ad-
dress/Netmask
Only for Type of traffic = ## % )3*! and NAT
method = (%
Enter the source IP address to which the original source IP ad-
dress is to be translated, with corresponding netmask, as the
case arises.
New Source Port Only for Type of traffic = ## % )3*!, NAT
method = (%, Service = $ and Pro-
12 Networking bintec elmeg GmbH
224 bintec RS Series
To Next Page
Loading...
