Rev 3.1 10. EtCO2 166
BM5 (CS,CX) User’s Manual
The airway adapters for mainstream intubated applications
Single-Patient Use Airway Adapter
Single-Patient Use Airway Adapter
Connecting the CAPNOSTAT® 5 CO2 Sensor to the Host System
1. Insert the CAPNOSTAT 5 CO2 Sensor connector into the receptacle of the host monitor as shown
in Figure 1.
2. Make sure the arrows on the connector are at the top of the connector and line up the two keys of
the connector with the receptacle and insert.
3. To remove the connector, grasp the body portion of the connector back and remove.
Note: Do not remove by pulling cable.
To Next Page
Loading...
