Specifications | 11
Minimum software versions:
l BioStack 4 basecode: PN 1230200 version 1.05 (or higher)
l Gen5: version 2.07 (or higher)
l LHC: version 2.18 (or higher)
l Note: Gen5 TS (for touch screen models) does not support stay-on lid mode.
Certain 6-, 12-, 24-, and 48-
well microplates with lids that
conform to ANSI/SLAS 2-2004
standard dimensions, as
specified, and with a:
l Minimum gap between plate
and lid when plate is on lid:
1.5 mm
l Maximum height of plate +
lid combined: 23.2 mm (also
called "stacked-plate-with-
lid" height)
Use calipers to measure the gap
between lid and plate.
Tall Lidded Plate Stacks
are required.
Uniquely designed stacks
labeled "Tall Lidded Plate
Stacks" support stay-on lid
mode and tall plate processing
without lids.
Stack Weights: PN 1230008
BioTek offers this accessory to
prevent the last plate's lid from
hanging in the stack during stay-
on lid mode. Better performance
was observed when using the
weights with taller-than-standard
plates without lids, as well.
Gen5 will keep the lid on the plate during processing when its plate type Lid
BioTek Instruments, Inc.
To Next Page
Loading...
Need help?
General
