Remove the Shipping Hardware—BioStack 3 | 21
Gripper arm cover and screws
4. Remove the plate carrier shipping screw.
5. Remove the rubber band that holds the rotational wrist secure.
Note: Do not let the gripper flop around! Before moving the BioStack 3 or BioStack 4,
secure the gripper with a rubber band or tape to prevent it from losing its alignment. A
complex recalibration is required if it is knocked out of position.
Save the shipping hardware
Installing the gripper arm cover
6. Locate and install the gripper arm cover using the small Phillips-head
screwdriver.
BioTek Instruments, Inc.
To Next Page
Loading...
