Task Procedures Illustrations
160
LEGACY
Mounting
Turnbuckle
support
mount
Tongue Linkage Assembly
1. Center and mount (a)
(AM4511) turnbuckle
support mount on
tongue frame with
(b) (BP3347) 5/8” x 4”W
x 5-5/8” L u-bolt, (c) (BP3039)
5/8” lock washers and
(d) ( BP3035) 5/8” hex
nuts. Do not tighten
until the linkage is
completely assembled.
2. Attach (d) (AM4512)
turnbuckle support to
support with (e) (BM3547)
1-1/4” x 5-3/4” double
grooved pin. Secure with
(f) (BP3249) 1-7/8” OD x
1-1/4” ID machine bushings
and (g) (AP2711) 1-1/4”
snap ring.
3. Attach (h) (AM6183)
tongue linkage cylinder to
support and turnbuckle (Insert
(i) (EM3735) 1-3/4” OD x 1.275”
ID bushing into turnbuckle loop
before securing to support.)
with (e) (BM3547) 1-1/4” x 5-3/4”
double grooved pin. Secure
with (f) (BP3249) 1-7/8” OD x
1-1/4” ID machine bushings
and (g) (AP2711) 1-1/4”
snap rings.
c
a
b
d
e
f
g
e
f
g
d
h
i
e
f
g
To Next Page
