43 MT55 Operation & Maintenance Manual
ATTACHMENTS (CONT’D)
Installing And Removing The Attachment (Bob-Tach) (Cont’d)
Removing
Figure 44
Lower the lift arms, put the attachment flat on the ground
and lower or close the hydraulic equipment.
Stop the engine and engage the parking brake.
If the attachment is hydraulically controlled (combination
bucket, tiller, etc.) stop the engine and relieve hydraulic
pressure at the quick couplers. (See Relieve Hydraulic
Pressure (Mini Track Loader And Attachment) on Page
31.)
Disconnect auxiliary hydraulic hoses.
Pull the Bob-Tach levers (Item 1) [Figure 44] all the way
up.
Perform the PRE-STARTING PROCEDURE. (See PRE-
STARTING PROCEDURE on Page 37.) Start the engine.
Release the parking brake.
Be sure the lift arms are all the way down. Tilt the Bob-
Tach forward. Move backward, away from the bucket or
attachment.
Bob-Tach levers have spring tension. Hold lever
tightly and release slowly. Failure to obey warning
can cause injury.
W-2054-1285
Before you leave the operator’s position:
• Lower the lift arm(s) fully.
• Stop the engine and engage the parking brake.
• Move all pedals, handles, joysticks, and other
controls until they are LOCKED or in the
NEUTRAL position.
SEE THE MACHINE OPERATION & MAINTENANCE
MANUAL FOR MORE INFORMATION.
W-2500-0404
Dealer Copy -- Not for Resale
To Next Page
Loading...