76 MT55 Operation & Maintenance Manual
ENGINE LUBRICATION SYSTEM (CONT’D)
Removing And Replacing Oil And Filter (Cont’d)
Figure 93
Remove the fill cap (Item 1) [Figure 93].
Put oil in the engine. (See Capacities on Page 113.) (See
Engine Oil Chart on Page 74.)
Install the fill cap.
Start the engine and let it run for several minutes.
Stop the engine and check for leaks at the oil filter.
Remove the dipstick and check the oil level.
Add oil as needed if it is not at the top mark on the
dipstick.
Install the dipstick and close the hood.
Close the side access cover.
AVOID INJURY OR DEATH
Always clean up spilled fuel or oil. Keep heat, flames,
sparks or lighted tobacco away from fuel and oil.
Failure to use care around combustibles can cause
explosion or fire.
W-2103-0508
Dealer Copy -- Not for Resale
To Next Page
Loading...