787 Flight Crew Operations Manual
DO NOT USE FOR FLIGHT
Normal Procedures -
Amplified Procedures
Copyright © The Boeing Company. See title page for details.
D615Z003-TBC NP.21.27
RIGHT ELECTRIC DEMAND pump selector – AUTO
Verify that FAULT light is extinguished.
CENTER 1 and CENTER 2 ELECTRIC pump selectors – AUTO
Verify that the FAULT lights are extinguished.
LEFT ELECTRIC DEMAND pump selector – AUTO
Verify that the FAULT light is extinguished.
Fuel panel ......................................................................... Set F/O
LEFT and RIGHT FUEL PUMP switches – ON
The PRESS lights are illuminated because of load shedding. If
the APU is running, the left aft pump PRESS light is
extinguished.
If the FUEL IN CENTER message shows:
CENTER FUEL PUMP switches – ON
Both PRESS lights illuminate until after engine start because
of load shedding.
BEACON light switch ......................................................ON F/O
CANCEL/RECALL switch ............................................Push F/O
Verify that only the expected alert messages are shown.
CANCEL/RECALL switch ............................................Push F/O
Verify that the messages cancel.
Trim .................................................................................. Set C
Stabilizer trim – ___ UNITS
Set the trim for takeoff.
Verify that the trim is in the greenband.
Rudder trim – 0 units
Call “BEFORE START CHECKLIST.” C
Do the BEFORE START checklist. F/O
February 15, 2010
To Next Page
Loading...
