Boeing 787-8 - Page 120

787 Flight Crew Operations Manual
DO NOT USE FOR FLIGHT
Normal Procedures -
Amplified Procedures
Copyright © The Boeing Company. See title page for details.
NP.21.34 D615Z003-TBC
Climb and Cruise Procedure
Complete the After Takeoff Checklist before starting the Climb and Cruise
Procedure.
Descent Procedure
Start the Descent Procedure before the airplane descends below the cruise
altitude for arrival at destination.
Complete the Descent Procedure by 10,000 feet MSL.
Pilot Flying Pilot Monitoring
At or above 10,000 feet MSL, set the
LANDING light switches to OFF.
Set the seatbelt signs as needed.
At transition altitude, set and crosscheck the altimeters to standard.
If the FUEL IN CENTER message shows,
set both CENTER FUEL PUMP switches to
ON.
When the FUEL LOW CENTER message
shows, set both CENTER FUEL PUMP
switches to OFF.
Before the top of descent, modify the active
route as needed for the arrival and
approach.
Verify or enter the correct RNP for the
approach.
Pilot Flying Pilot Monitoring
Review all alert messages.
Review all operational notes.
Recall and review all alert messages.
Recall and review all operational notes.
Verify VREF on the APPROACH REF
page.
Enter VREF on the APPROACH REF
page.
Set the RADIO/BARO minimums as needed for the approach.
Set the NAV RADIO page for the approach.
Set the AUTOBRAKE selector to the
needed brake setting.
Do the approach briefing.
Call “DESCENT CHECKLIST.” Do the DESCENT checklist.
February 15, 2010