Boeing 787-8 - Page 119

787 Flight Crew Operations Manual
DO NOT USE FOR FLIGHT
Normal Procedures -
Amplified Procedures
Copyright © The Boeing Company. See title page for details.
D615Z003-TBC NP.21.33
Takeoff Flap Retraction Speed Schedule
Verify V1 speed. Verify the automatic V1 callout or call
“V1.”
At VR, rotate toward 15° pitch attitude.
After liftoff, follow F/D commands.
At VR call “ROTATE.”
Monitor airspeed and vertical speed.
Establish a positive rate of climb.
Verify a positive rate of climb on the
altimeter and call “POSITIVE RATE.”
Verify a positive rate of climb on the
altimeter and call “GEAR UP.”
Set the landing gear lever to UP.
Above 400 feet radio altitude, call for a roll
mode as needed.
Select or verify the roll mode.
Verify VNAV engaged.
Verify that climb thrust is set.
Verify acceleration at the acceleration
height.
Call “FLAPS___” according to the flap
retraction schedule.
Set the flap lever as directed.
Engage the autopilot when above the
minimum altitude for autopilot
engagement.
After flap retraction is complete, set the
ENGINE ANTI-ICE selectors to AUTO.
Call “AFTER TAKEOFF CHECKLIST.”
Do the AFTER TAKEOFF checklist.
Takeoff
Flaps
At “Display” Select
Flaps
20 or 15
VREF 30 + 20
“5”
“1”
5
1
UP
5VREF 30 + 40
“1”
1
UP
Pilot Flying Pilot Monitoring
February 15, 2010