787 Flight Crew Operations Manual
DO NOT USE FOR FLIGHT
Normal Procedures -
Amplified Procedures
Copyright © The Boeing Company. See title page for details.
D615Z003-TBC NP.21.43
After Landing Procedure
Start the After Landing Procedure when clear of the active runway.
[Option – GE engines]
Engine cooldown recommendations:
• Run the engines for at least 3 minutes
• Use a thrust setting no higher than that normally used for all engine
taxi operations
[Option – RR engines]
Engine cooldown recommendations:
• Run the engines for at least 5 minutes
• Use a thrust setting no higher than that normally used for all engine
taxi operations
Pilot Flying Pilot Monitoring
The captain positions or verifies that the SPEEDBRAKE lever is DOWN.
Set the APU selector to START, then ON, as
needed.
Set the ENGINE ANTI-ICE selectors to
ON, if needed.
Set the exterior lights as needed.
Set the weather radar to off.
Set the AUTOBRAKE selector OFF.
Set the flap lever to UP.
Set the transponder mode selector as
needed. At airports where ground tracking
is not available, select STANDBY. At
airports equipped to track airplanes on the
ground, select TRANSPONDER.
February 15, 2010
To Next Page
Loading...
