bora PUXU - Inserting the Cooktop; Height Adjustment Plates for Flush Installation(Optional); Securing the Cooktop

EN
27
Installation
www.bora.com
1 2
Fig. 6.21 Height adjustment plates
[1] Sealing tape
[2] Optional height adjustment plates
XO
The height adjustment plates are self-adhesive to prevent
slipping during installation.
XX
If necessary, lay the height adjustment plates [2] underneath.
XX
Place the height adjustment plates next to the sealing tape
[2].
6.6.4 Securing the cooktop
1
2
3
Fig. 6.22 Securing the cooktop in the middle
[1] Cooktop
[2] Installation clamp
[3] Fixing bracket
XX
Secure the cooktop to the worktop [1] with the fixing bracket
[3] on the installation clamp [2] .
XX
Tightening torque: max. 2.2 Nm.
6.6.3 Inserting the cooktop
54321
Fig. 6.19 Inserting the cooktop
[1] Cooktop
[2] Inlet opening
[3] Air inlet nozzle
[4] Stainless steel grease filter
[5] Worktop cut-out
XX
Before inserting the cooktop, remove the air inlet nozzle [3]
and the stainless steel grease filter [4].
XX
Use the inlet opening [2] as a handle during insertion.
XX
Keep the cooktop [1] straight as you lift it into the worktop
cut-out [5]
XX
Insert the cooktop [1] into the centre of the worktop cut-out
[5].
XX
Precisely align the cooktop.
Information regarding surface mounting:
XX
make sure that the cooktop sealing tape is flat against the
worktop.
Information regarding flush installation:
XX
make sure that the cooktop sealing tape is well sealed all the
way round.
Height adjustment plates for flush
installation(optional)
1
2
Fig. 6.20 Inserting height adjustment plates
[1] Cooktop
[2] Height adjustment plate