bora PUXU - Inserting the Cooktop; Height Adjustment Plates for Flush Installation (Optional); Securing the Cooktop; Making a Connection with the Back Wall (Only in Installation Variant A)

EN
33
Installation
www.bora.com
1 2
Fig. 6.38 Height adjustment plates
[1] Sealing tape
[2] Optional height adjustment plates
XO
The height adjustment plates are self-adhesive to prevent
slipping during installation.
XX
If necessary, lay the height adjustment plates [2] underneath.
XX
Place the height adjustment plates next to the sealing tape
[2].
6.7.8 Securing the cooktop
1
2
3
Fig. 6.39 Securing the cooktop
[1] Cooktop
[2] Installation clamp
[3] Fixing bracket
XX
Secure the cooktop to the worktop [1] with the fixing bracket
[3] on the installation clamp [2] .
XO
Tightening torque: max. 2 Nm
6.7.9 Making a connection with the back wall
(only in installation variant A)
1
3
2
Fig. 6.40 Connection with the back wall
[1] Telescopic pull-out
[2] Adhesive tape
[3] Back wall of unit
6.7.7 Inserting the cooktop
54321
6
Fig. 6.36 Positioning the cooktop in the centre
[1] Cooktop
[2] Inlet opening
[3] Air inlet nozzle
[4] Stainless steel grease filter
[5] Worktop cut-out
[6] Adhesive tape
XX
Before inserting the cooktop, remove the air inlet nozzle [3]
and the stainless steel grease filter [4].
XX
Remove the protective film from the adhesive tape [6] on the
front of the telescopic pull-out.
XX
Use the inlet opening [2] as a handle during insertion.
XX
Keep the cooktop [1] straight as you lift it into the worktop
cut-out [5]
XX
Insert the cooktop [1] into the centre of the worktop cut-out
[5].
XX
Precisely align the cooktop.
Information regarding surface mounting:
XX
make sure that the cooktop sealing tape is flat against the
worktop.
Information regarding flush installation:
XX
make sure that the cooktop sealing tape is well sealed all the
way round.
Height adjustment plates for flush installation
(optional)
1
2
Fig. 6.37 Height adjustment plates
[1] Cooktop
[2] Height adjustment plate