HIPERFACE® (12 V supply voltage)
See the connection diagram for how to connect the encoder system.
Connection diagram
1) Line cross section ≥ 0.5 mm²; observe allowed encoder cable
length
2) Line cross section ≥ 0.14 mm²
Fig. 8-3: HIPERFACE® encoder system connection diagram
Power supply
The HIPERFACE® encoder system requires a 12 V supply voltage. This sup‐
ply voltage is made available via the EC interface.
Technical specification of the power supply: See chapter "12 V power supply"
on page 92
Observe that the third-party encoder used must be suited for the
voltage
available at the EC interface as the encoder supply volt‐
age.
Cable length
The
maximum possible cable length depends on several factors: See chapter
8.1.4 "Encoder cable length" on page 94
DOK-INDRV*-CXX02******-PR03-EN-P Bosch Rexroth AG 81/143
IndraDrive Control Sections CSB02, CSE02, CSH02, CDB02
Technical data - functions
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com
To Next Page
Loading...
