7.17.3 Standard Control Panel HAP01.1N
For a detailed description of the control panel, see the documen‐
tation "Application Manual, Functions
" of the firmware used.
In the future, the standard control panel HAP01.1N will be re‐
placed by the standard control panel HAP01.1E.
Fig. 7-9: Standard Control Panel HAP01.1N
Description
The standard control panel
● has a single-line display
● must have been plugged in when the drive controller is switched on so
that it can be recognized (not suited for hot plug)
● can be used as programming module
● The display shows operating states, command and error diagnoses and
pending warnings.
● Using the four keys, the commissioning engineer or service technician
can have extended diagnoses displayed and trigger simple commands.
● Memory
– 400 kbytes for MLD boot program
– 492 bytes for MLD retain variables
Bosch Rexroth AG DOK-INDRV*-CXX02******-PR03-EN-P78/143
IndraDrive Control Sections CSB02, CSE02, CSH02, CDB02
Optional connection points
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com
To Next Page
Loading...
