7.4 Required accessories
• Leg set for holding up the conveyor unit.
Please note: Support the section in the immediate vicinity of the drive and return
unit and under each section joint. The maximum distance permitted between
two leg sets is 2000 mm.
– For SE 2/C, SE 2/R:
SZ 2, 3 842 996 320
SZ 2/U, 3 842 996 322
SZ 2/T, 3 842 996 324
– For SE 2/C-H, SE 2/R-H, SE 2/R-V:
SZ 2-H, 3 842 996 321
SZ 2/U-H, 3 842 996 323
SZ 2/T-H, 3 842 996 325
• For fastening the leg sets on the ground, you need the following for each
connection:
– 1x foundation bracket, 3 842 146 815
– 1x dowel, 3 842 526 560
– 2x T-bolt, 3 842 528 718
– 2x fl ange nut, 3 842 345 081
• Connection kit for transverse conveyor, for utilization of the conveyor unit in
lateral transverse conveyor (drive head-at-section).
– AS 2/C-100, AS 2/C-250, AS 2/R-300, AS 2/R-700 with:
ST 2/B, ST 2/B-100, ST 2/C-100, ST 2/R-100, 3 842 528 192
– AS 2/C-400, AS 2/C-700, AS 2/R-1200, AS 2/R-2200 with:
ST 2/B, ST 2/B-100, ST 2/C-100, ST 2/R-100, 3 842 518 828
– SE 2/C-H, SE 2/R-H, SE 2/R-V with:
ST 2/C-H, ST 2/R-H, ST 2/R-V, 3 842 528 192
• Connection kit for longitudinal conveyor (drive head at return unit)
– AS 2/C-100, AS 2/C-250, AS 2/R-300, BS 2/R-700 with:
AS 2/C-100, AS 2/C-250, AS 2/R-300, AS 4/R-700, 3 842 529 881
– AS 2/C-400, AS 2/C-700, AS 2/R-1200, AS 2/R-2200
SE 2/C-H, SE 2/R-H, SE 2/R-V with:
AS 2/C-100, AS 2/C-250, AS 2/R-300, AS 2/R-700,
AS 2/C-400, AS 2/C-700, AS 2/R-1200, AS 2/R-2200
SE 2/C-H, SE 2/R-H, SE 2/R-V, 3 842 530 871
24/108 Assembly
Bosch Rexroth AG, MIT: SE 2/C-…, SE 2/R-…, 3 842 358 737/2022-08
To Next Page
Loading...
