Bosch rexroth SE 2/C Series - Modifying the Mounting Position of the Motor-Gear Combination or the Gear Motor

7.6.18 Modifying the mounting position of the motor-gear combination
or the gear motor
Fig. 35:
358 736-84
90
90
90
90
SW8
2x
M
D
= 6 Nm
A
A
A
A
Swiveling the motor-gear combination around the drive axle
1. Remove the screws (A).
2. Pivot the motor-gear
combination around
the drive axis in 90°
intervals.
3. Install the screws (A).
48/108 Assembly
Bosch Rexroth AG, MIT: SE 2/C-…, SE 2/R-…, 3 842 358 737/2022-08