Bosch rexroth SE 2/C Series - Motor Mounting (MA) = R;L

10.4.10 Shortening the conveyor chain: AS 2/C-100, …-250, AS 2/R-300, …-700,
motor mounting (MA) = R/L
Fig. 57:
358 736-41
AS 2/R-700AS 2/R-300
AS 2/C-250AS 2/C-100
1
)
75
3 842 535 333
8 981 010 510
6
2 9
4 8
6
3
SW19
3
SW10
1
SW10
M = 8 Nm
D
M = 8 Nm
D
4x
2x
1
3
)
4
)
Shortening the conveyor chain AS 2/C-100, …-250, AS 2/R-300, …-700, MA = R/L (1/2)
Please note:
Perform the steps on both
sides in parallel.
1. Remove the gear motor.
2. Disassemble the outer
protective case halves.
3. Using a wrench,
turn the drive shaft
in the conveying
direction until the
chain lock appears on
the chain tensioner.
You recognize the
chain lock:
– of the fl at top chain
by the gray fl at chain
with hole see
1
).
– of the accumulation
roller chain by the
galvanized tab, see
2
).
Maintenance and repair 73/108
3 842 358 737/2022-08, MIT: SE 2/C-…, SE 2/R-…, Bosch Rexroth AG
ENGLISH