Bosch rexroth SE 2/C Series - R-V-1200

7.6.17 Assembling the conveyor chain: AS 2/C-400, …-700, …R-1200, …-2200,
…R-V-1200, …-2200, motor mounting (MA) = M
Fig. 34:
3
3
4
M
4x
D
= 7 Nm
SW4
M
4x
D
= 7 Nm
SW4
2
2
1
358 736-36
AS 2/C-…, AS 2/R-…, AS 2/R-V-…, MA = M: Assembling the conveyor chain
Please note:
• Same assembly
sequence as for motor
mounting (MA) = R/L
(see page 45),
but the drive shaft must be
disassembled instead of
the gear motor.
Disassembling the
drive shaft:
1. Remove the side
cover plates.
2. Remove the locking rings
from the hexagonal shaft.
3. Slide the hexagonal shaft
out of the drive.
Store the protective tube
for reuse.
Assembling the drive shaft:
1. Push the hexagonal shaft
into the drive.
While doing so, insert
the protective pipe.
Secure the hexagonal
shaft with locking rings.
Assembly 47/108
3 842 358 737/2022-08, MIT: SE 2/C-…, SE 2/R-…, Bosch Rexroth AG
ENGLISH