10 Maintenance and repair
WARNING
High electrical voltage!
Risk of severe injury or death from electric shock.
Disconnect the relevant system component before performing any maintenance
or repair work.
Secure the system against being unintentionally switched on again.
High pneumatic pressure!
Risk of severe injury or death.
Switch off the compressed air supply to the relevant system component before
performing any maintenance or repair work.
Secure the system against being unintentionally switched on again.
CAUTION
Hot electric motor surfaces during operation!
Risk of burns from touching hot surfaces above 65 °C
Install appropriate guards.
Let the unit cool down for at least 30 minutes before performing maintenance
and/or repair work.
• Only inspect and adjust continuous conveyors that are in motion or operation
when the protective equipment is in place.
• Observe DIN EN ISO 13857 when you remove or replace safety guards and/or
bypass protective equipment.
• Test runs with open paneling should only be performed by a person with
appropriate knowledge and experience using tip switches, and if there is no
possibility of interference from other switching devices.
Maintenance and repair 63/108
3 842 358 737/2022-08, MIT: SE 2/C-…, SE 2/R-…, Bosch Rexroth AG
ENGLISH
To Next Page
Loading...
