Bosch rexroth SE 2/C Series - Shortening the Conveyor Chain: as 2;C-400; As 2;R-V-1200

Maintenance and repair 77/108
3 842 358 737/2022-08, MIT: SE 2/C-…, SE 2/R-…, Bosch Rexroth AG
10.4.12 Shortening the conveyor chain: AS 2/C-400, …-700, AS 2/R-1200, …-2200,
AS 2/R-V-1200, …-2200, motor mounting (MA) = R/L
Fig. 61:
2
9
2
7
8
4
1
)
5 6 7
X
"X"
3
M
4x
D
= 7 Nm
SW4
M
4x
D
= 7 Nm
SW4
SW10
M
D
= 8 Nm
SW27
1
AS 2/C-...
358 736-45
8 981 010 510
4
)
3 842 535 333
3
)
Shortening the conveyor chain AS 2/C-400, …, AS 2/R-1200, …, AS 2/R-V-1200,
MA = R/L (1/2)
Please note:
Perform the steps on both
sides in parallel.
1. Remove the gear motor.
2. Remove the side cover
plates, remove the
bottom cover sheets.
3. Using a wrench, turn
the drive shaft in the
conveying direction
until the chain lock
appears on the chain
tensioner.
You recognize the
chain lock:
– of the fl at top chain by
the gray fl at chain with
hole see
1
).
– the accumulation roller
chain by the galvanized
tab see
2
).
3
) Disassembly tool:
– For fl at top chain:
3 842 010 510
4
) Chain lock:
– For fl at top chain:
3 842 535 333
ENGLISH