Bosch rexroth SE 2/C Series - Motor Mounting (MA) = R;L; Replacing the Motor And;Or Gear as 2;C-100, as 2;R-300, Motor Mounting (MA) = R;L

Maintenance and repair 91/108
3 842 358 737/2022-08, MIT: SE 2/C-…, SE 2/R-…, Bosch Rexroth AG
10.4.20 Replacing the motor and/or gear AS 2/C-100, AS 2/R-300,
motor mounting (MA) = R/L
Fig. 73:
563 833-60
4
SW8
M
D
= 5 Nm
(4x)
X
Antiseize
3
5
gleitmo 585K
2
1
SW8
M
D
= 5 Nm
(2x)
Replacing the motor and/or gear, motor mounting (MA) = R/L
Please note:
• The end faces of the motor and gear must be undamaged.
• The gear hub comes lubricated with anti-seize lubricant.
• Do not tilt the motor and make sure that there is enough clearance area for the
motor assembly.
• Install the motor in the proper position (terminal box) and connect it to the gear.
If the motor is not in the proper position: Do NOT rotate the motor. Disconnect
the motor from the gear and reconnect it.
If only the motor is to be
replaced, start with item 4.
1. Loosen the hexagon
screws on the fl ange.
2. Remove the motor-gear
combination from the
hexagonal shaft.
3. Remove the cover plug
from the defective gear
and insert it at the
new gear.
4. Loosen the hexagon
screws on the gear
fl ange.
5. Disconnect the defective
gear from the motor.
6. Remove the yellow
protective cap (X) from
the motor shaft of the
new motor.
Grease the motor shaft.
7. Install the motor.
8. Install the motor-gear
combination.
ENGLISH