8.2 Residual risks
Table 7: Residual risks
Location Situation Hazard Action
1 Conveyor medium pinch
point
Pieces of clothing or
long hair can be pulled
in
Crushing,
pulling out of
hair
Do not reach into the system while it is
running. Wear protective clothing.
2 Cross connector; gear;
drive shaft:
Between component and
workpiece pallet
Trapping of limbs
Crushing,
Shearing
Do not reach into the system while it is
running.
At workspaces, crush and shear points on
roller conveyors, suspension chain conveyors or
multiple belt conveyors between rollers, drive
shafts, cross struts or fi xed parts and moving
bulk goods must be secured. Risks of crushing
and shearing may be deemed avoided if the
static force for stopping the load is less than
150 N.
3 Conveyor medium:
between running
conveyor and stationary
workpiece pallet
(e.g. during separation)
Trapping of limbs
Crushing Do not reach into the system while it is
running.
4 Between workpiece
pallets
Trapping of limbs
Crushing,
Shearing
Do not reach into the system while it is
running.
At workspaces, relative movements of
loads (e.g. at accumulating conveyors)
which lead to the loads approaching
a distance of less than 500 mm must be
avoided. (e.g. through pre-separation of the
workpiece pallets)
Risks of crushing may be deemed avoided if
the static force for stopping the load is less
than 150 N.
5 End of conveyor unit Crushing injury to
body parts caused by
falling objects
Crushing A constructive solution is required,
e.g. by means of a stopper.
6 Section transfers
Trapping of body parts
between conveyor
medium (fl at top chain,
roller chain) and
workpiece pallet
Crushing Do not reach into the system while it is
running. In the working area and at transport
speeds v > 15 m/min a structural solution,
e.g. a safety fence,
is required.
Commissioning 59/108
3 842 358 737/2022-08, MIT: SE 2/C-…, SE 2/R-…, Bosch Rexroth AG
ENGLISH
To Next Page
Loading...
