7.6.8 Assembling the conveyor units drive head-to-return unit
Fig. 21:
563 833-72
3 842 529 881
52
M
D
= 15 Nm
SW5
=
=
5
2
2
4
4
1
3
3
5
1
Assembling the drive head-to-return unit, AS 2/C-100, -250, AS 2/R-300, -700
Required accessories for
AS 2/C-100, …-250,
AS 2/R-300, …-700:
• Connection kit
3 842 529 881 (1x)
1. Disassemble the outer
protective case halves.
2. Slide the connection kit
into the T-groove at the
drive head.
3. Align the return unit
of the adjacent belt
section and position
it without a gap at the
height of the drive
head.
4. Install the connection
kit centrally between
drive head and return
unit.
5. Mount the outer halves
of the protective case.
36/108 Assembly
Bosch Rexroth AG, MIT: SE 2/C-…, SE 2/R-…, 3 842 358 737/2022-08
To Next Page
Loading...
