BradyPrinter S3700 User Manual 139
Regulatory Compliance
Wireless Regulatory Information
Wireless Regulatory Information
Regulatory markings, subject to country certification, are applied to host printer signifying Wi-Fi and
Bluetooth (radio) approvals have been obtained.
United States
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at own expense.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and, (2) this device must accept any
interference received, including interference that may cause undesired operation.
Co-located statements: To comply with FCC RF exposure compliance requirement, the antenna
used for this transmitter must not be co-located or operating in conjunction with any other
transmitter/antenna except those already with radio module filing.
RF exposure guidelines / Important note: This equipment complies with FCC SAR exemption limits
set forth for an uncontrolled environment and properly used as instructed.
WARNING! Operation of the device without regulatory approval is illegal.
Radio protocol WLAN IEEE 802.11b/g/n BLE
RF Operating Frequency 2.412 – 2.462 GHz 2.402 – 2.480 GHz
RF Output Power < +20dBm EIRP (100mW) < +20dBm EIRP (100mW)
Antenna Type \ Antenna Gain PCB trace antenna \ 2.3 dBi PCB trace antenna \ 2 dBi
Environmental Operation -40 to 85° C (-40° to 185° F)
Note: Be mindful of the maximum operating temperatures for the printer.
See “Physical and Environmental Characteristics” on page 2.
Environmental Storage -55 to 125° C (-67° to 257° F)
Note: Be mindful of the maximum storage temperatures for the printer.
See “Physical and Environmental Characteristics” on page 2.
To Next Page
Loading...
