BradyPrinter S3700 User Manual 6
Setup
Power
Power
1. Plug the power cord into the power cord connection port on the right side of the printer.
2. Plug the other end of the power cord into an electrical outlet.
3. Turn the On/Off switch to the ON position to power up the printer.
The printer automatically displays the primary Home Page. The size and color of the currently
installed label supply and ribbon and other status indicators are shown.
Note: If there is no ribbon or label installed, the system defaults to black ribbon and 4" (101.6 mm)
wide continuous white media.
CAUTION! Before connecting power, be sure to remove the desiccant from
inside the printer.
To Next Page
Loading...
