Brocade MLX Series and NetIron XMR Hardware Installation Guide 285
53-1003821-01
Replacing fan assemblies
7
2. Remove the old air filter by pulling it straight out from the router, as shown in Figure 163.
3. Insert a new filter, being careful that it aligns within the narrow channel.
4. Repeat steps 2 and 3 to replace the second filter.
5. Replace the air inlet cover and tighten the four captive screws to secure the air filter to the
router.
FIGURE 163 Air filter removal and replacement for 32-slot routers
1 Direction of airflow in device
To Next Page
Loading...
