Operation Manual
FT1020G3 Rev 2.4
36
User Level 2B
After the door has been opened using 003 key ("Door open" symbol in the symbol
area), you have access to level 1 and after log on as “Building officer” (level 2B), access
to the following menus:
H2 Disable or re-enable
B1 Zone or Zone / Address
B2 Output
B3 Output type
B4 Alarm devices
B5 Routing equipment
B6 Alert annunciation function
H3 Set calendar and clock
H4 Present system status
U1 Disablement
U2 Disablement by time channel
U3 Open doors
U4 Sensor values
U5 Sensors activating SERVICE signal
U6 Technical warning
U7 Event log
U8 Information
H6 FAULT Acknowledge
H7 Perform ZONE TEST ("Test mode")
H9 Interlocking outputs and inputs
C1 Activated interlocking outputs / inputs
C2 Activate / deactivate interlocking output
C3 Disable / re-enable interlocking output
H10 Change password (In this case for “Building officer”.)
User level 3A
After the door has been opened using 003 key ("Door open" symbol in the symbol
field), the service / maintenance personnel have access to level 2B and after log on as
“Service personnel” (level 3A), access to all menus, i.e. same as level 2B and also to the
following menus:
Same menus as in access level 2B plus the following:
A1 Calibration of supervised outputs
A2 Sensitive fault detection mode
A3 Service mode for COM-loop
A4 Display current consumption in Control Unit
A5 Display current consumption on COM-loop
A6 Display statistics for communication
To Next Page
Loading...
