Operation Manual
FT1020G3 Rev 2.4
79
4. Report the Serial number to Brooks engineering office in order to get the
password.
58
5. Write the new number of alarm points and the
received password in the field respectively
and click "Write".
Follow the same procedure in each Control Unit if a TLON network requires upgrade.
After you enter the password, right click on the respective Control Unit icon and choose
“Properties”. The Control Unit Properties dialog box opens:
Depending on the upgrade password you received, under the “Misc” section, the
“Configured number of alarm points” will be made available.
Note: All Control Units connected in a TLON network do not have to have the same
maximum number of alarm points.
58
To upgrade the maximum number of alarm points, a special PC program is used to generate a password. The password will
be unique for every serial number and number of alarm points combination.
To Next Page
