Chaprter 3 Programming with Command Function
Programmer
153
4. The needle point moves to B.
5
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
6
Ending program
1. Press
P
.
Deleting the escape point
The escape point is deleted. The example in the left
is used for explanation of deleting A.
1
Calling data
1. Specify the program number on the
operation panel and press the read/write
switch to read the data.
2
Moving to position A.
1. Press
1
and press .
The work clamp moves to the escape point.
To Next Page
Loading...
Need help?
General
