Programmer
163
Chapter 3 Programming with Command Function
Creating a circle (zigzag circle) by specifying 3 points
Command to be used
LI
2
0
Input the overlap stitch counts in Values 0 - 9 are
available for input.
M
7
Input this command to create a zigzag circle. Input the zigzag
width in .
The zigzag width can be specified from 1.0 - 25.5 mm.
To specify the width of 10.0 mm or more, input
M
7
0 0
and input the width in 3 digits, then press
M
.
Example: Pitch Input
3.5mm
M
7
3 5
18.0mm
M
7
0 0
M
1
8 0
M
Input this command to create a zigzag circle. Input the zigzag
stitch length in .
Example: Pitch Input
0.5mm 005
12.0mm 120
1. Select the sewing start position with and press
L
.
2. Input
LILI
2
0
.
3. Input the stitch length in 3 digits and press
LILI
.
To Next Page
Loading...
Need help?
General
