Programmer
45
Chapter 2 Programming with Help Function
8. Press
ESCESC
.
9. Select with and press .
10. Select ON/OFF of needle stopping at the
bottom with
and press .
11. Program pattern 2.
12. Program pattern 3 in the similar manner.
13. When pattern 3 is programmed, press
.
2
Inputting the end code
1. Select with and press .
2. Select the end code type with
and
press
.
"111" is selected in the example. Press and the work clamp
returns to the first stitch(point A).
3. Press
ESCESC
.
The work clamp returns to the home position.
3
Saving
1. Select with and press .
To Next Page
